CC-309-2WS - Concrete Curing Compound

03 39 23

No. 1141 (CA)

Specification

CC-309-2WS™
Water-Base, Resin-Base Concrete Curing Compound

DESCRIPTION
CC-309-2WS water-base, white-pigmented curing compound is a resin-base dispersion with selected white pigments. When properly applied, the product provides a nearly impermeable film, which optimizes water retention. The white pigment reflects the sun’s rays to help kept the concrete surface cooler and help prevent excessive heat build-up.

CC-309-2WS meets the maximum VOC content limit of 350 g/L for concrete curing compounds as required by the U.S. EPA Architectural Coatings Rule.

USES
CC-309-2WS is designed for application on exterior, horizontal surfaces, such as highways, airports and street and curb paving – the product provides excellent curing when protection from the sun’s heat is desired.

PHYSICAL PROPERTIES
Drying Time: Typically dries in 1-2 hours. Drying times may vary, depending on application rate, temperature, humidity and project conditions. Restrict foot traffic for at least four (4) hours. Twelve (12) hours is preferable.

Flash Point: Greater than 200° F (93° C)

APPLICATION
Preparation: Application equipment must be clean and free of any previously used materials.

Mixing: Any settling or separation in the container must be re-dispersed with gentle agitation prior to use. CAUTION: TO AVOID FOAMING, DO NOT MIX EXCESSIVELY.

Application Method:Spray on in one even coat with a hand or power sprayer as soon as the surface water disappears from horizontal concrete surfaces. On vertical surfaces, spray on promptly after the forms are removed. Use a Chapin 5797 or equivalent spray tip that produces a flow of ½ gallon (1.89 L) per minute under 40 psi (.276 MPa) of pressure.

Coverage: Approximately 200 ft²/gal. (4.91 m²/L).

Clean-up: Prior to drying, application equipment can be cleaned up with soap and water. Once dried, it will be necessary to use mineral spirits or other suitable petroleum distillate.

PRECAUTIONS
KEEP FROM FREEZING. Do not apply when the temperature of the concrete is less than 40° F (4° C). DO NOT MIX WITH COMPOUNDS CONTAINING SOLVENT – SEPARATION WILL OCCUR. DO NOT ADD OR DILUTE WITH ANY OTHER COMPOUND. Do not use on surfaces that are later to be painted, tiled, hardened, sealed or treated in any manner. Do not use on patios, sidewalks or other areas where there is typically no wheel traffic to abrade the white film surface. Not recommended for use on residential driveways. Read and follow application information.

For use on roadways and bridges only. (Not for use on curbs and gutters, sidewalks, islands, driveways, and other miscellaneous concrete areas.)

HEALTH HAZARDS
Direct contact may result in mild irritation. Refer to product Material Safety Data Sheet for complete health and safety information.

For MSDS or further assistance, please call 1-800-342-5976.

This material last updated June 2007