Product Data Sheet
|32 01 17.61||
DATA SHEET 2900-1100
1100 RUBBERIZED CRACK FILLER
1100 RUBBERIZED CRACK FILLER is an emulsified asphalt containing rubber and selected fillers designed for sealing cracks in asphalt and concrete pavements. It is cold applied.
1100 RUBBERIZED CRACK FILLER is designed for sealing cracks in asphalt and concrete pavements.
- Cold-applied/Ease of application
- Seals cracks in both asphalt and concrete
18.9 L (5 U.S. Gal.) Pails
205 L (54.2 U.S. Gal.) Drums
1000 L (265 U.S. Gal.) Totes*
Also available in bulk
*Lightweight Disposable Tote System
7 m/L (87 ft./gal.)
When stored indoors in original, unopened containers at temperatures between 4° – 32° C, optimum performance and best use is obtained within two years of date of manufacture.
- Complies with Alberta Transportation Specification EC-101
|Colour||Brown; Black when cured|
|Solids Content||Approximately 65%
Skins in 15 minutes at average spring temperature
|Viscosity @ 25º C||70 – 90 Krebs|
|Uniformity||Smooth in consistency; no settlement|
Rate of Curing
|55 – 60%|
Surface Preparation … Clean cracks and joints and remove all loose material using compressed air. Fill deep cracks to within 51 mm (2″) of pavement with clean sand.
Application Method … Apply with gravity-feed type pour pots or diaphragm pump system. Sprinkle sand or cement powder on uncured material to prevent tracking. Some cracks may require refilling after the application has cured. Minimum application temperature is 10º C.
Clean-Up … Use water to clean up fresh material. Dried material may be cleaned up with mineral spirits.
DO NOT FREEZE. Minimum application temperature is 10º C. Do not use if there is a possibility of rain. Refer to Safety Data Sheet for complete Health and Safety information.
MASTERFORMAT NUMBER AND TITLE
32 01 17.61 – Sealing Cracks in Asphalt Paving
May help contribute to LEED credits:
- MRc9: Construction and Demolition Waste Management