Product Data Sheet
|07 11 13||
DATA SHEET 7110-505
Fibrated Foundation Coating
505 SEALMASTIC fibrated foundation coating is an asphalt-based, cutback type, fibrated dampproofing coating.
505 SEALMASTIC fibrated foundation coating is designed to be used for dampproofing and waterproofing masonry and concrete walls and for dampproofing and waterproofing concrete floors.
- Ready to use … no heating or thinning required.
- Dries rapidly … fast and economical way to protect concrete and masonry foundation walls from moisture penetration.
- Easy to apply … no special equipment needed.
- Crack resistant.
18.9 Litre (5 U.S. gallon) Pails
Coverage is 0.39 – 0.74 m2/L (16 – 30 ft.2/gal.) depending on porosity of the surface.
When stored indoors in original, unopened containers at temperatures between 4° – 32° C, optimum performance and best use is obtained within two years of date of manufacture.
Complies with CGSB 37-GP-16M. To be applied according to CGSB 37-GP-36M.
|Weight||1 kg/L (10 lb./gal.)|
|Drying Time||Touch dry: 3.5 hours|
|Firm dry: 24 hours|
|Water Content||1% Maximum|
|Flash Point||40° C|
Surface Preparation … Surface shall be firm and free from loose particles, cracks, grease, oil, and other foreign matter. Surface must be free from frost, snow, and ice.
Application Method … At temperatures below 4o C, use a prime coat of 600 ASPHALT PRIMER from W. R. MEADOWS applied at a minimum rate of 4.1 m2/L (200 ft.2/U.S. gal.). Apply by spray or brush at least one coat of 505 SEALMASTIC. Protect cured application from damage by using PROTECTION COURSE (VIBRAFLEX® PC) and MEL-DRAIN™ from W. R. MEADOWS.
If there is excessive hydrostatic pressure on the surface, a more complete waterproofing specification must be used. Consult a technical representative for further assistance. If material has thickened due to low temperatures, leave the containers in a heated building overnight. Do not heat with an open flame. Contains flammable solvents. Keep away from heat and open flames. Use in a well-ventilated area. Avoid use where solvent odours are objectionable
MASTERFORMAT NUMBER AND TITLE
07 11 13 – Bituminous Dampproofing
May help contribute to LEED credits:
- IEQ Credit 3.1: Construction Indoor Air Quality Management Plan – During Construction
- MR Credit 2: Construction Waste Management
- MR Credit 5: Regional Materials