Product Data Sheet
|07 10 00||DATA SHEET 7100-205|
Rolled Matrix Drainage System
MEL-DRAIN drainage products combine geotextile filter fabrics with specially designed drainage cores. This geocomposite allows the passage of moisture through the fabric while preventing fine soils from entering the drainage channel. Various drain designs are available, depending on compressive strength and flow rate requirements. (An optional polyester backing film is available when used in conjunction with flexible waterproofing material.) The family of MEL-DRAIN products provides excellent protection and drainage performance for vertical, horizontal, or site drainage applications.
Used in conjunction with a total W. R. MEADOWS moisture protection system, MEL-DRAIN is the ideal choice for enhanced waterproofing protection of basement walls, plaza decks, earth-sheltered homes, commercial buildings, retaining walls, underground parking, site drainage, etc.
- High flow capacity, without clogging/Relieves hydrostatic pressure build-up.
- High compressive strength/Dependable, long-life performance.
- Easy to install; durable under jobsite conditions/ Lower total installed cost.
- Chemically resistant to all naturally-occurring soil conditions/Wide variety of applications.
- Provides added protection for waterproofing materials/Enhances waterproofing performance.
- Part of a complete W. R. MEADOWS moisture protection system/Worry-free, single-source solution.
For vertical, below-grade applications, unroll MEL-DRAIN with flat, core side against the wall or waterproofing material. POINTING MASTIC or MEL-PRIME™ from W. R. MEADOWS are excellent adhesives compatible with this installation. The flat side core lip is overlapped to provide a continuous drainage layer. Extra filter fabric is provided at the edges for overlapping with the next sheet. MEL-DRAIN is easily cut with construction knives or scissors.
For horizontal applications, unroll and overlap so that water runs with overlap. Add appropriate ballast as needed to hold down drainage board.
Store materials in protected environment until time of installation. Materials not shipped in UV‐resistant bags must be stored indoors or under separate UV‐protective cover to protect materials from exposure to direct sunlight. UV‐resistant bagged materials may be stored in outdoor UV‐exposed environments for a cumulative maximum of 180 days. Limit unpackaged material UV exposure to a cumulative maximum of 14 days during installation. Do not install materials during high wind events. Do not expose materials to chemicals that are strong acids, strong bases, or high in solvents content. Protect materials from site construction damage, flames, and other environmental conditions that may damage the materials. It is not recommended that installation take place when the ambient temperature is below -6.6°or above 37.8°C. Do not install in applications where the long term operational temperature is expected to be below -18.9° C or above 65.6° C.
MASTERFORMAT NUMBER AND TITLE
07 10 00 – Dampproofing and Waterproofing
May help contribute to LEED credits:
- EAp2: Minimum Energy Performance
- EAc2: Optimize Energy Performance
- MRc9: Construction and Demolition Waste Management