SPECTRUM 910 (Canada)

Product Data Sheet

03 35 33

DATA SHEET 3300-910

SPECTRUM 910
Liquid Stamp Release “Cherry Blast”

DESCRIPTION
SPECTRUM 910 liquid stamp protectant is a blend of natural and synthetic chemicals that protects decorative concrete texturing tools from the alkaline concrete surface. Working with SPECTRUM 910 is more tolerable to applicators, due to the refreshing “cherry blast” scent that accompanies its application.

USES
SPECTRUM 910 is ideal for use on fresh concrete surfaces where no secondary colour is required. SPECTRUM 910 can be used on polyurethane, metal, fiberglass, and rubber decorative concrete tools for efficient protection from fresh concrete surfaces.

FEATURES/BENEFITS

• Minimizes wear and tear to decorative concrete tools.
• Is a clear liquid and will not affect the final appearance of a concrete project.
• Can also be used in combination with SPECTRUM 930 patina acid stain and various sealers from W. R. MEADOWS.
• Allows for the surface to be reworked if needed … simply trowel surface smooth, reapply SPECTRUM 910, and re-stamp.

PACKAGING
18.9 Litre (5 U.S. Gal.) Pails

COVERAGE
6.1 – 8.6 m²/L (250 – 350 ft.²/U.S. gal.)

SHELF LIFE
When stored indoors and in original, unopened containers at temperatures between 4° – 32° C, shelf life is two years from date of manufacture.

APPLICATION
Surface Preparation … Clean existing debris from all stamping tools. Ensure that concrete is sufficiently set and that all bleed water has dissipated from concrete surface. Concrete surface should also be at a stage where it is able to support the load of workers as well as any tools that are required.

Application Method … Liberally apply SPECTRUM 910 by commercial sprayer (such as a Chapin 19069) with a 1.9 LPM nozzle to the decorative concrete tools and to the concrete surface. Ensure that the surface is uniformly covered. SPECTRUM 910 stamp protectant should not be applied too far in advance, as evaporation of the product may occur.

NOTE: SPECTRUM 910 liquid stamp protectant should be applied in a clean, even mist in order to prevent spotting. Place the decorative concrete texturing or stamping mats over the area that has been covered with SPECTRUM 910. Using an impact tool, ensure that the concrete surface is adequately stamped for depth of texture. Remove the decorative concrete texturing mats from the concrete surface. Allow the concrete to set for a minimum of 24 hours.

Sealing … Seal the concrete surface using DECRA-SEAL_™ or DECRA-SEAL W/B from W. R. MEADOWS. If there is a concern that the surface may be slippery when wet, use DECK-O-GRIP_® or apply SURE-STEP_™ from W. R. MEADOWS in the final coat of sealer applied to the concrete surface.

Cleanup … Application equipment should be cleaned promptly after use with mineral spirits or xylene.

PRECAUTIONS
Use SPECTRUM 910 liquid stamp protectant in an adequately ventilated area. It is recommended that a painter’s mask or a personal respirator be worn during the sprayer application. Combustible liquid. Keep away from ignition sources. For exterior use only.

HEALTH AND SAFETY
Avoid contact with skin and eyes. If skin contact occurs, wash affected area immediately with soap and water. Refer to Material Safety Data Sheet for complete health and safety information.

MASTERFORMAT NUMBER AND TITLE
03 35 33 – Stamped Concrete Finishing

LEED INFORMATION
May help contribute to LEED credits:

• MR Credit 2: Construction Waste Management
• MR Credit 5: Regional Materials

Material last updated April 2014.

---

Technical Literature