SURE-STEP (Canada)

Product Data Sheet

03 05 00

DATA SHEET 3050-340

SURE-STEP_™
Slip-Resistant Additive

DESCRIPTION
SURE-STEP slip-resistant additive is a finely ground polymer material for addition to concrete sealers for slip resistance.  This additive can be added to most film-forming water-based and solvent-based sealers, including the CS-309_™, SEAL-CURE_™, and VOCOMP_® series, as well as HIAC_™ and DECRA-SEAL_™ from W. R. MEADOWS.  Please consult sealer manufacturer prior to using, if using a product not listed above.

SURE-STEP provides improved abrasion resistance and is more comfortable to bare feet on treated surfaces than sand or aggregate additives.  The product’s low density and insolubility characteristics will help reduce settling and provide optimum performance in its various applications without changing the viscosity.  Due to its low density, SURE-STEP stays suspended in thin materials.

USES
SURE-STEP is perfect for use on areas where a slip-resistant surface is desired.  This includes walkways, driveways, garage floors, patios and other surfaces.

FEATURES/BENEFITS

• Provides improved abrasion resistance.
• Does not change viscosity.
• Allows easy cleaning of the surface.
• Provides slip-resistance properties on surface without sacrificing comfort for barefoot traffic.

PACKAGING
453.6 G (16 Oz.) Containers

COVERAGE
Recommended for 18.9 litre (5 U.S. gallon) pails.

SHELF LIFE
When stored indoors in original, unopened containers at temperatures between 4° – 32° C (40° – 90° F), optimum performance and best use is obtained within two years of date of manufacture.

APPLICATION
Surface Preparation … Follow surface preparation directions of sealer being applied.

Application Method … SURE-STEP is designed to be incorporated into a suitable concrete sealer.  Minimum addition ratio is 453.6 g (16 oz.) per 18.9 L (5 U.S. gallon) pail.  Additional SURE-STEP can be added, depending on the desired texturing effect.  Do not exceed 226.8 g (8 oz.) per 3.79 L (1 U.S. gallon).  Stir, while adding SURE-STEP to the container of sealer.  The product may float at first, but once it has wet out, it will mix in easily.  In thinner products, occasional stirring during application may be required to keep the particles well suspended within the coating.  It is recommended that when mixing SURE-STEP into unfamiliar sealers that a small test batch be mixed, followed by a small test application.

Drying Time … Follow directions of sealer being applied.

Clean Up … Follow directions of sealer being applied.

PRECAUTIONS
SURE-STEP will increase the texturing effect of a sealer, but the addition of the slip resistant additive should not be considered non-skid, anti-skid, or non-slip.  Under some conditions, the granules may be visible.  Depending on the surface, this may alter colour or dull the surface.  A small application test section is recommended.

HEALTH AND SAFETY
SURE-STEP is not hazardous and does not contain silica, but should be treated as a nuisance dust while incorporating it into its intended vehicle.  Use with adequate ventilation.  Use appropriate, properly fitted respirator protection filter apparatus and avoid breathing dust and particles.  If dizziness, headache or eye watering occurs, get to fresh air; leave area immediately.  In case of eye contact, flush with large amounts of water for at least 15 minutes.  Seek medical attention if irritation persists.  Do not take internally.  If swallowed, seek medical attention immediately.  Keep out of reach of children.  Close container after each use.  Use protective clothing to avoid contact with skin and eyes. Refer to Safety Data Sheet for complete health and safety information.

MASTERFORMAT NUMBER AND TITLE
03 05 00 – Common Work Results for Concrete

LEED INFORMATION
May help contribute to LEED credits:

• MRc9: Construction and Demolition Waste Management

2017-11

---

Technical Literature