Product Data Sheet
|03 15 13|
DATA SHEET 5125-000
WATERSTOP EC PLUS
WATERSTOP EC PLUS is comprised of a sodium bentonite/hydrophilic rubber combination designed to provide a superior watertight seal while at the same time offering the ability to work in an environment subjected to continuous wetting and drying cycles. Full hydration and/or dehydration takes approximately four days.
WATERSTOP EC PLUS is used to seal static construction joints in concrete footings, walls, floors, tunnels, and parking and plaza decks and to prevent water migration. WATERSTOP EC PLUS has superior performance when used under conditions of extreme water head. WATERSTOP EC PLUS is compatible with all waterproofing membranes available from W. R. MEADOWS.
- When properly applied, stops water migration through cast-in-place concrete construction joints after confinement.
- Returns to original placement and size after one prolonged hydration cycle.
- Resistant to a variety of chemical contaminates common to urban water and soil samples.
Standard rolls sizes:
6.4 mm x 25.4 mm x 5.1 m (¼” x 1″ x 16′ 8″)
12.7 mm x 25.4 mm x 5.1 m (½” x 1″ x 16′ 8″)
19.1 mm x 25.4 mm x 5.1 m (¾” x 1″ x 16′ 8″)
Each carton provides 30.5 lm (100 LF) of coverage. Rolls are packaged six per carton. Protect product from moisture in storage. Store on skid or pallet. Cover with polyethylene or tarp.
Surface Preparation … Surface should be clean and dry. For optimum adhesion to concrete, use CLAY-TITE MASTIC from W. R. MEADOWS. Place bead of material across surface before installation of WATERSTOP EC PLUS. Concrete should cover 50 mm (2″) surrounding the WATERSTOP EC PLUS application area.
Application Method … After applying CLAY-TITE MASTIC, remove the thin liner and press the product into place. The product should be applied with the nylon side up. After WATERSTOP EC PLUS is hand-pressed into place, then install standard masonry nails. The nails should be placed 304.8 mm (12″) apart. After the nails are placed, release the thick liner. Then concrete can be poured or placed.
Do not install in standing water or over ice. WATERSTOP EC PLUS is not designed, nor intended to function, as an expansion joint sealant. WATERSTOP EC PLUS is designed to seal structural concrete joints with a minimum 20.7 MPa (3000 psi compressive concrete strength. If WATERSTOP EC PLUS has eclipsed 24 hours of continuous submersion, allow an appropriate or equal time to dry before placement of concrete or replace with new product. CLAY-TITE MASTIC may be applied over damp surfaces, but must not be applied over dust, debris or standing water as proper adhesion will not take place
MASTERFORMAT NUMBER AND TITLE
03 15 13 – Concrete Accessories – Waterstops
May help contribute to LEED credits:
- MRc9: Construction and Demolition Waste Management
|Property||Test Method||WATERSTOP EC PLUS Results|
|Weight||0.4 kg/m (0.25 lb./linear foot)|
|Tear Strength: Membrane||ASTM D1004||333 N (75 lb.)|
|% Elongation at Break||ASTM D638||>150%|
|Unrestricted Expansion||300% over 4 days|
|Installation Temperatures||ASTM D746||-26˚ to 49˚ C|
|Freeze/Thaw Cycles||No effect before or after installation.|
|Resistance to Hydrostatic Head||ASTM D5385||70 m (231′) of water|
|Vapor Permeability||ASTM D5084||1 x 10-9 cm per sec|