|03 35 33||
DATA SHEET 3300-920
Powder Stamp Release for Decorative Concrete
SPECTRUM 920 powder stamp release is a blend of natural and synthetic chemicals formulated to provide quick, easy, and clean release of concrete from decorative concrete texturing tools. It is available in 20 standard colours. By using SPECTRUM 920 powder stamp release, workers are able to create a two-tone colour look to their project, also known as “antiquing.”
SPECTRUM 920 powder stamp release is used on fresh concrete surfaces as a bond breaker and colouring agent.
- SPECTRUM 920 powder stamp release acts as a bond breaker/adds secondary colour to decorative concrete surfaces.
- SPECTRUM 920 powder stamp release ensures the safe and efficient release of concrete from decorative concrete tools/minimizes wear and tear to decorative concrete tools.
- SPECTRUM 920 powder stamp release creates a unique, two-tone “antique” look to any project.
- SPECTRUM 920 powder stamp release is available in 20 standard colours.
16 Kg (35 Lb.) Pails
On average, SPECTRUM 920 will yield 69.7 – 92.9 sq. m (750-1,000 sq. ft) or 0.17 – 0.19 kg/sq. m (3.5 – 4 lb../100 sq. ft.) of coverage per pail.
NOTE: Coverage may vary dependant on desired result. Please contact a W. R. MEADOWS representative for further coverage information.
One year in an unopened container, stored in a dry area away from moisture.
Surface Preparation … Clean existing debris from all stamping tools. When working with a fresh concrete surface, ensure that the concrete is sufficiently set, and that all bleed water has dissipated from the surface to be worked on.
Application Method … Liberally apply SPECTRUM 920 powder stamp release by broadcasting the material over the concrete surface. Ensure that the surface is uniformly covered for proper release of the decorative concrete tools.
Place the decorative concrete texturing or stamping mats over the area that has been covered with SPECTRUM 920 powder stamp release. Using an impact tool, ensure that the concrete surface is adequately stamped for depth of texture. Remove the decorative concrete texturing mats from the concrete surface. SPECTRUM 920 powder stamp release should remain in a dry state on the concrete surface – the product should not be worked into the surface. Allow the concrete to set for a minimum of 24 hours.
Using a pressure washer and/or rotary floor machine, clean the concrete surface to remove any excess release agent. Do not attempt to remove excess release agent until concrete has attained sufficient strength. Premature removal of release agent may damage the concrete surface.
Sealing … Seal the concrete surface using DECRA-SEAL™ or DECRA-SEAL W/B from W. R. MEADOWS. If there is a concern that the surface may be slippery when wet, apply DECK-O-GRIP® or SURE-STEP™ from W. R. MEADOWS in the final coat of sealer applied to the concrete surface.
Cleanup … Tools may be cleaned with soap and water.
HEALTH AND SAFETY
Avoid direct contact with this product as well as inhalation of dust. If dust is generated, the use of respiratory equipment (dust mask) is recommended. If contact with the skin or eyes occurs, flush area with water. Consult product material safety data sheet (MSDS) for complete health and safety information.
2011 MASTERFORMAT NUMBER AND TITLE
03 35 33 – Stamped Concrete Finishing
May help contribute to LEED credits:
Material last updated February 2011.