![]() 1. Install PRECON according to installation instructions onto soil stabilization system. Allow a minimum of 12″ overlap to extend around outside corner. | ![]() 2. Cut PRECON on the horizontal to allow for ease of bending around corner and mechanically fasten according to installation instructions. | ![]() 3. Apply HYDRALASTIC 836 to all overlap areas of PRECON that will be accepting the subsequent sheet of PRECON. |
![]() 4. Install overlapping PRECON according to installation instructions onto soil stabilization system. Cut PRECON on the horizontal to allow for ease of bending around corner. | ![]() 5. Embed overlaps into pre-applied HYDRALASTIC 836 and roll press into place. | ![]() 6. Apply HYDRALASTIC 836 at all overlapping joints in a 12″ wide application and then fully embed detail fabric into this HYDRALASTIC 836. Terminate all edges with additional HYDRALASTIC 836. |
INSIDE CORNER INSTALLATION INSTRUCTIONS | ||
![]() 1. Install PRECON according to installation instructions onto soil stabilization system. | ![]() 2. Cut PRECON on the horizontal to allow for ease of bending around corner. | ![]() 3. Mechanically fasten according to installation instructions. |
![]() 4. Apply HYDRALASTIC 836 to the area of PRECON that will be accepting the PRECON overlap, fold down overlap and embed in the HYDRALASTIC 836. Roll press into place. | ![]() 5. Apply HYDRALASTIC 836 at all overlapping joints in a 12″ wide application and then fully embed DETAIL FABRIC into this HYDRALASTIC 836. Terminate all edges with additional HYDRALASTIC 836. |
Resources: